|
Ideal for Spill Prevention
The VeriGAP is ideal for high and low point level measurements in non-coating liquids.
It is not affected by variations in viscosity, density, pressure,temperature, or electrical properties.
The Dual Veri-GAP™ level switch is economical for processes requiring two operating points, such as batch processing and sump applications. This level control provides two operating on one sensor, so there is only one unit to install and maintain. It requires only one opening in the vessel for the sensor, and no calibration.
One adjustable-length Veri-GAP™ sensor handles a wide range of applications. The operating point can be changed in seconds and adjusted along the entire length of the standard 36-inch sensor.
No Calibration of any Kind Needed
The unit needs no calibration or gain adjustments, regardless of the material to be measured.
No opportunity for error in calibration or adjustments in gain controls.
Measurement is not affected by variations in liquid viscosity, density, pressure or electrical properties.
Completely Self-Checking
A special patented Verify circuit lets you meet spill prevention regulations and prevent unnecessary down-time, lost products, and regulatory fines.
Verify™ circuitry checks that the complete system (crystals, crystal bonding, electronics and relay) is functioning correctly. The optional Verify™ test checks not only the electronics, but also the relay and the entire control loop, including final control elements
The VeriGAP level switch is the only safe gap switch available for high level alarming or indication.
With most low-level fail-safe devices, either an absence of material or a component failure will indicate a low level alarm.
With most high level fail-safe devices, the presence of material will only trigger an alarm if the system is functioning properly. A component failure, such as separation of the crystals, will cause the device to indicate an absence of material.
This will result in a normal condition, even if the tank is over filling.
Simple, Economical Installation
One piece design for simplified installation and operation. Sensing element is easily installed in existing vessel openings, and of course...no calibration is needed.
Two-Wire and Line Powered Units Available
Check Downloads for individual Unit Specifications. | 
;)
