The Fluke 787 ProcessMeter™ was the first tool to combine a DMM and a loop calibrator to give process technicians double the power in one tool. Now it’s even better, the range is extended with the new Fluke 789 ProcessMeter™ – the ultimate loop calibration multimeter.
The Fluke 789 ProcessMeter™ has a 24-Volt loop supply reducing the need for taking a separate power supply when doing offline transmitter testing. And with its built-in, selectable 250-Ohm Hart® resistor, it also eliminates the need to carry a separate resistor with you. Now process technicians can do a lot more while carrying a lot less.
Key New Features of the Fluke 789
24 V Loop power supply
HART mode setting with loop power (adds 250 ohm resistor)
100% larger dual display
1,200 ohm drive capability on mA source
Enhanced backlight with two brightness settings
0-100 % mA Span Check buttons to toggle between 4 and 20 mA
Infrared I/O serial port compatible with FlukeView® Forms Software Version 2.1 (available Feb. 2003)
Externally accessible fuses for easy replacement
DMM designed to meet 1000 volt IEC 1010 CAT III standards
Precision 1000 V, 440 mA true-rms digital multimeter
Frequency measurement to 20 kHz
Min/Max/Average/Hold/Relative modes
Diode Test and Continuity Beeper
Simultaneous mA and % of scale readout
20 mA dc current source / loop calibrator / simulator
Manual Step (100 %, 25 %, Coarse, Fine) plus Auto Step and Auto Ramp
Externally accessible battery for easy battery changes
;)
Key New Features of the Fluke 789 
No. de pièce: 
