The Millennium RM2 is a 2-channel rack mount controller designed to offer you the ultimate in control and versatility! Create the monitoring system to suit your installation requirements by combining any two of Net Safety's Fire detectors, Toxic gas sensors or Combustible gas transmitters. Now you can save money and safeguard your installation against a variety of potential hazards or cover multiple zones with a single monitoring device.
Independent Channels!
The RM2's independent channels eliminate the standard industry limitation of monitoring only fire OR only gas by adding a new level of flexibility - combining Fire AND Gas detection! The RM2 functions as the centralized display and alarm point for any combination of two independent Fire and Gas detectors, expanding both your zone and hazard protection.
Flexible Configuration!
Setup, operate, monitor and maintain the RM2 using the Front Panel Push button or connect a PC or even PDA via the serial communications port. Either way, you decide HOW and WHERE you operate the RM2. The RM2 contains custom designed software and a number of user programmable options to configure the RM2 to exactly suit your needs - in the field - on demand!
Information At-A-Glance!
The RM2 is designed to make operation and maintenance simple - without compromising safety or reliability! Specifically designed with end user input, the RM2 shows you what you need to know quickly and easily. Each channel has its own clearly visible display with helpful prompts to guide you through setup and maintenance tasks. Bright LEDs visually indicate warnings and alerts for each input channel and the RM2 circuitry.
Reduced Operating Costs!
False alarms cost $$$! With the RM2's independent channels, activity on one channel does not affect the other channel so a variety of tasks and activities can be performed without initiating false alarms. And, the RM2's superior functional design decreases the time necessary to perform most routine operational and maintenance tasks saving you money!
Features
RS-232 Serial Communications Port - Connect a PC or PDA
Channel Specific, Jumper Selectable Analog Output-Isolated/Non-Isolated
Pluggable Terminals
Protected Memory
Conformal Coated Circuit Board
Internal System Electronic Watchdog Timer
Rails to Easily Slide into Cages
Calibration/Reset Button
4-Character Scrolling Display
Common System LEDs Indicate System and Fault Status
5 SPDT Relays (2 Per Channel/1 Common Fault) Jumper Selectable as Normally Open or Closed
Relay Set Points (System Fault, Gas-High/Low, Fire-High/Low)
;)
