`
The TXDIN1600 Series is a new generation DIN rail mounted temperature transmitter. It has been designed to accept most common process and temperature sensor inputs and provide the user with a standard two wire 4 to 20 mA output signal. Isolation is provided between input and output and all temperature ranges are linear to temperature.
Isolation | Input to output tested at 500 Vdc |
Ambient | Operating -20 to 70°C (-4 to 158°F) 10 to 95% RH non-condensing |
Storage | -40 to 85°C (-40 to 185°F) |
Approvals | CE tested to BS EN 61326 |
Dimensions | 17.5 W x 56.4 L x 90 mm H (0.7 x 2.2 x 3.5") |
Material | Polmide 6.6 |
Self Extinguishing Terminals | Screw terminal |
Cable | 2.5 mm (0.1") max |
Color | Gray Output |
TXDIN1610 | |
Type | 2-wire current sink; signal range 4 to 20 mA; full range 3.8 to 24 mA |
Supply | 11 to 30 Vdc, 24V nominal giving max loop load of 600 R @ 24V |
Response Time | <500 ms to reach 95% of final value; start up time <3 s |
Calibration Accuracy | ±5 uA |
Loop Effects | Loop ripple 0.03% of FSR; supply sensitivity 0.05 uA/°C; supply ripple rejection Protection: Reverse connection and over-voltage protection, max over voltage current 100 mA |
User Trim | Raise and lower buttons, active for offset when output is between 3.8 to 6 mA, span between 18 to 22 mA, trim lock option |
TXDIN1620 | |
Type | 3-wire voltage output with |
programmable ranges | 0 to 10, 0 to 5, 2 to 10, 1 to 5, and 0 to 1V |
Supply | 15 to 28 Vdc |
Response Time | <500 ms to reach 95% of final value; start up time <3 s |
Calibration Accuracy | ±5 mV |
Output Drive | 2 mA driving 5 KΩ @ 10V |
Protection | Reverse connection and over-voltage protection, max over voltage current 100 mA |
User Trim | Raise and lower buttons, active for offset when output is at offset and span, trim lock option |
TXDIN1630 | |
Type | Dual form C relay contacts |
Supply | 24 Vdc ±5% @ 40 mA max |
Response Time | <500 ms to reach 95% of final value; start up time <3 s |
Contact Rating | 250 Vac rms @ 1 A; 30 Vdc @ 1 A resistive load |
Trip Type | Individual trips A and B may be set at high or low level, full range setpoint plus adjustable |
Ranges | Setpoint programmed on units, covering full range of input |
Hysteresis | Set in units |
Protection | Reverse connection and over-voltage protection, max over voltage current 100 mA |
View All Part Numbers