Dwyer

Replacement sensor, 12' cable

J type, 100' on spool, FEP insulation, 200°C, black outer sheath, 24 AWG, 0.20 SQMM

J type, 100' on spool, fiber glass insulation, 450°C, black outer sheath, 24 AWG, 0.20 SQMM

Allow for easy installation of blow tube through the dust collector wall

Indicators and strips; displays both °F and °C

Single or triple vane paddles for PLS series level switch

Differential pressure gage bleed fitting used w/ the Capsuhelic gage as a readout device when measuring fluids, pressure drop across...

Probes for the Dwyer TS2, TSS2, TSWB, TSW, TS3, TSX3, and 40 M series

0 V - 3 V humidity probe that includes a 4 ft (1.2 m) cable

Vane thermo-anemometer probe with coiled cable

For use in place of water if better meniscus is desired

LCD digital panel meter, 4 - 20 mA loop-powered, green segments

High pressure hose for the PCHP-1 hand pump

Cable gland with 1/2 in male NPT fitting helps seal and protect cable connections to the transmitter

Model RP1, Wired Thermo-Hygrometer Probe for the Model 485B.

Intrinsically safe shunt-diode barrier to be used to communicate with & provide isolation for certain Dwyer transmitters approved...

Surface mounting bracket for use with ISDP pressure transmitters

For use with special instruments and Mark II Models 26 and 28

Air velocity calculator slide chart makes spot checking with Dwyer pitot tubes quick and easy

Fast, convenient installation of pitot tubes in sheet metal ducts

ASME design meets AMCA and ASHRAE codes for a corrosion-resistant stainless steel tube with permanently etched insertion depth...

Optional extra kit for the Rate-Master Flowmeters and Visi-Float Flowmeters

Fast, accurate indication of vacuum or differential pressures, suitable for internal pressures up to 500 PSIG

Mounting gland with 1/2 in male NPT

Split mounting flange for use with pitot tubes and probe assemblies

Flange mounting plate with 1/2 in female NPT

Protective magnetic rubber boot for manometers (manometer not included)

303 SS static pressure tip with mounting flange for 3/16 in ID rubber or plastic tubing

Protective rubber boot for use with Dwyer DPG series

Flush mount bracket for Capsuhelic gauge

Direct drive pressure gage brass adapter, 1/4 in male NPT to G 1/2 A parallel thread 1-1/2 in length

Plastic static pressure tip

S-type mounting bracket

4 in straight static pressure tip with flange

316 SS flat mounting bracket with bolts

316 SS angle mounting bracket with bolts

Norprene Tubing

Shut off valve, brass, 1/8" NPT to 1/4" metal tubing

Thermometer and terminal tube holder, stainless steel wire.

Measures velocity, flow, and temperature

Replacement vane for Dwyer MW-1 wind meter

Leak proof body and float constructed from tough, durable polyphenylene sulfide which has excellent chemical resistance, all at a...

NDIR sensing technology with a 2000 ppm range monitors the occupancy in a room by detecting concentrated carbon dioxide

Dual-line alpha-numeric display, auto calibration

Low cost and high performing CO2 sensor

Enables you to quickly balance maximum CO2 with minimum smoke for clean, efficient combustion

A compact, high performance unit with a low price

A compact, high performance unit with a low price