Automotive

Standard replacement sensor for the AII GPR-2600 oxygen analyzer

Replacement sensor with a lowest range of 0-50 ppb for use with the AII PI2 oxygen analyzer

HART-USB modem with DIN retail and ATEX

4 each 1.125" (28.5 mm) diameter access ports with a window configuration (ST Models Only)

Standard replacement sensor for the aII GPR-1200 and PI2 oxygen analyzers

Replacement sensor for CO2 backgrounds for use with GPR-1100, GPR-1200, GPR-1500, GPR-1600 and GPR-1900 oxygen analyzers

Mini-USB to full USB cable

Weather-proof enclosure that provides means to protection-mount all Macurco 6-Series gas detectors in non-hazardous locations

Airtight enclosure that provides a means to mount any Macurco gas detector to an air duct

Rubber boot

Panel mount bracket

Rubber boot, rear port

Rubber boot, bottom port

4-pin bayonet mating connector (E3) with 5 ft. cable ( L1, L3, L10 only)

HART - USB modem with DIN rail

HART- USB modem

¾ in. NPT mount junction box with one liquid tight connector and cap with junction terminals

Rotor with PVDF Black, PVDF Natural or ETFE (Tefzel) material options

Transmitter integral mounting kit- NPT, valox, polypropylene or PVDF options

Retaining nut replacement kit- retaining nut, NPT, valox or polypropylane or PVDF

Universal mount junction box

Universal mounting kit

Digital input plug-in module slot A

RS-485 communications plug-in module slot A

Triac plug-in module slot 2

SSR driver plug-in module slots 2 and 3

Angle adapter for Meriam well type included tube manometers

Plastic line trap, ring type, for Meriam well type manometers

Indicating fluids for the Meriam manometers

N.I.S.T. certificate / scale for Meriam manometers

1/4 in NPT street elbow in steel for the 10AA25 Clean-Out U-Type manometer

Float check valve for Meriam manometers

Four channel swith input module for the QEL Q-Controller

Type K thermocouple with 6 in x 1/8 in dia and a 36 in. long lead wire

Stainless steel sintered filter, 30 microns with fittings

Rated for 150 PSIG, The HP125 gets installed into a 3.5 inch diameter PVC threaded pipe flange, 4 bolt install, includes rubber gasket

Rated for 300 PSIG, The HP125 gets installed into a 3.75 inch diameter 304 SS Threaded Pipe Flange, 4 bolt install, includes rubber...

Bearing

Gasket

Heavy duty hard case with pre-cut foam inserts for the Dwyer UHH2 and additional sensors

Neck strap for the DS701 and DS703 FC diagnostic videoscopes

Replacement sensor with a lowest range of 0-100 ppb for use with the AII PI2 oxygen analyzer

End clip for DIN rail

1 meter length DIN rail

Conductive level with control switch, 1 or 2 SPDT relay and 24-240 V AC/DC or 24 V AC/DC output

USB to mini-USB cable for use with the Dwyer UHH2 universal handheld base unit

Provides the system with improved chamber temperature uniformity

Provides a gas flow rate of 10 to 40 Liters per minute; however this option is only available with the 2500ST model