Product Finder

Coin cell for in-transit data loggers with a -20°C - 70°C operating environment

150°C, 1/2 AA high-temperature battery

Simple mounting clamp that can be attached to tripods or extension poles with a 1/4 - 20 mounting screw

Sensor adapter for 3 yr. oxygen sensor for the Fyrite INSIGHT Plus

Fyrite user software CD for the Fyrite INSIGHT Plus

Oxygen sensor cap (for 2-year sensor, includes gasket) for the Fyrite INSIGHT Plus

IrDA printer with magnet and disposable batteries for the Fyrite INSIGHT Plus

Replacement combustible sensor for the Informant 2

0019-0510 Replacement refrigerant sensor for the Informant2

Probe tip filters for the H25-IR PRO

Tune-up kit for the H-10 PRO

Replacement combustible gas sensor for the Leakator Jr

Hand strap for the MFC5150

Soft carrying case for the MFC5150

Allows sanitary pressure gauges and transmitters to be installed on lines as small as 1/4” without - need for adaptors or reducers,...

Boot for the MGF16BN digital gauge

Test lead kit for the Meriam M4 series

Oxygen Sensor (2 yrs.) for the PCA3, Fyrite INSIGHT Plus, Fyrite InTech, and Monoxor Plus

Enables the detector to be rotated up to ±3° in the X-Y directions in order to provide fine alignment

Adjustable mounting bracket that provides accurate directional selection for optimum area coverage

Enables the user to connect to any available PC or laptop to re-configure settings or perform diagnostics

Pre-loaded with Spectrex software, enables the user to re-configure settings or perform diagnostics on all Spectrex flame and gas...

It brings fire prevention safety to a higher level by giving you the ability to fully test the operational readiness of your entire...

Enables the designer and installer to optimize the detector's location and the actual detection area coverage of each installed...

Protects from tough environmental conditions where they may be exposed to oil vapors, sand, dust and other particulate matter

Available with 1/8 in or 1/16 in NPT needle

Enables the designer and installer to optimize the detector's location and the actual detection area coverage of each installed...

Protects from tough environmental conditions where they may be exposed to oil vapors, sand, dust and other particulate matter

Enables the designer and installer to optimize the detector's location and the actual detection area coverage of each installed...

Protects from tough environmental conditions where they may be exposed to oil vapors, sand, dust and other particulate matter

Designed to protect the detector from rain and snow

Designed to protect the detector from rain and snow

Protects the detector from rain and snow and direct extreme temperatures from the sun

Protects the detector from direct extreme temperatures from the sun

Available to facilitate either 2” or 3” pipe mounting

Hydrophobic filter with internal water stop for the multi- and single-zone refrigerant leak detectors

Norprene Tubing

High accuracy modular pressure references for the Setra MicroCal

Replacement refrigerant sensor filters (5 pk.) for the Informant 2

12 inch probe for the Fyrite InTech and Monoxor Plus

SmartButton USB adapter, requires TrendReader for SmartButton Software

SmartButton logger to PC USB port interface cable, requires TrendReader for SmartButton software

Customized weatherproof enclosure designed for use with the QuadTemp, OctTemp, QuadTemp2000, and OctTemp2000 data loggers

Weatherproof enclosure designed for use with MadgeTech's 101A series data loggers

Ni-Mh 1 hour charger with four (4) Ni-Mh AA batteries

230 V, 50 Hz AC adapter for M334

Variable power supply plugs into a micro-USB power jack and includes four interchangeable prong configurations

Duct flange for Setra SRH humidity sensors