Product Finder

Enables the designer and installer to optimize the detector's location and the actual detection area coverage of each installed...

Protects from tough environmental conditions where they may be exposed to oil vapors, sand, dust and other particulate matter

Designed to protect the detector from rain and snow

Designed to protect the detector from rain and snow

Protects the detector from rain and snow and direct extreme temperatures from the sun

Protects the detector from direct extreme temperatures from the sun

Available to facilitate either 2” or 3” pipe mounting

Hydrophobic filter with internal water stop for the multi- and single-zone refrigerant leak detectors

Norprene Tubing

High accuracy modular pressure references for the Setra MicroCal

Replacement refrigerant sensor filters (5 pk.) for the Informant 2

12 inch probe for the Fyrite InTech and Monoxor Plus

SmartButton USB adapter, requires TrendReader for SmartButton Software

SmartButton logger to PC USB port interface cable, requires TrendReader for SmartButton software

Customized weatherproof enclosure designed for use with the QuadTemp, OctTemp, QuadTemp2000, and OctTemp2000 data loggers

Weatherproof enclosure designed for use with MadgeTech's 101A series data loggers

Ni-Mh 1 hour charger with four (4) Ni-Mh AA batteries

230 V, 50 Hz AC adapter for M334

Variable power supply plugs into a micro-USB power jack and includes four interchangeable prong configurations

Duct flange for Setra SRH humidity sensors

High pressure quick connection fittings set for use under 10,000 PSI (max)

High pressure hose connection kit for use up to 10,000 PSIG (max)

Maintenance kit for the H-10 PRO

Replacement probe tip for the H-10 PRO

North American line splitter, separates hot/neutral lines between electrical device and receptacle, includes a 10x multiplier

120 V power supply for SmartReader Plus networks

Allows a SmartReader Plus logger to be added to an ACR network

Allows a SmartReader Plus logger to be added to an ACR-stereo type network, 1 male and 2 female ends

For instrument installations that require higher total current output than the PVSP24U

6.2 mm wide, used for supplying the In-Rail-Bus DIN rail connector with supply voltage

pH/ORP Wet-Tap allows installation & removal of pH or ORP electrodes without the need for process shutdown

Protective rubber lining that seals out moisture and a stainless steel cover that protects against damage

B Smart replacement sensor for the PCA3

Water trap/filter assembly (for probe hose assembly) for the Fyrite INSIGHT Plus

Probe stop for all Bacharach combustion analyzers

Replacement battery charger for PGM-IR (for 87 Wh battery 3015-5743)

Rechargeable battery pack for the PGM-IR

Development board for the EL-OEM-3

Universal power adapter for the 2000 series (LCD display) data loggers

36 in high-temperature flexible RTD probe with M12 connector for use with the HiTemp140-M12 data logger

Precision 100 Ω, 4 wire RTD probe, with a 6 in sheath (72 in leads)

Used to sample gas from a remote location where a sensor cannot be placed

Remote switch for the QEL Q-Controller

LED annunciator panel used with the M-CONTROLLER

Remote Relay Modules to be used with the M-CONTROLLER

The development kit for the 7” PanelPilotACE compatible display, SGD 70-A

Add-on board allowing RS485 communication.

Terminal cover for Fuji PXF series controllers